Electric Wiper Kit | For Skid Steer Excavator SXS

Listed by SkidSteerCabs.com, LLC

12-Volt Electric Wiper Kit for Polycarbonate Cab Doors Keep a working view through an SSC cab door with a compact electric wiper package built around a 12-volt motor, adjustable arm, and right-parking sweep. The kit was developed for polycarbonate skid steer enclosure doors and can also suit compatible excavator, tractor, and side-by-side panels when the mounting surface and electrical system match. This is not a direct OEM wiper-motor replacement. Factory glass, splined shafts, bolt patterns, and wiring can differ even when the finished wiper looks similar. Measure the panel and compare the mounting layout before drilling. Wiper dimensions and sweep - 1-1/2-inch motor shaft for standard and thicker forestry-style polycarbonate doors. - 55-degree wiper angle. - 13-3/4-inch wiper blade. - Adjustable arm from 11 to 15 inches. - Approximate adjustable sweep from 21 to 24 inches. - Right-parking action that stops the blade away from the normal sight line. Before mounting, hold the arm and blade against the intended location through the full 55-degree arc. Does the blade stay on the clear panel? Will it clear the door frame, handle, and seal? Is the parked blade outside the operator's main view? Establish the motor location from those checks rather than drilling from a generic diagram. Motor, switch, and wiring The toggle switch sits on the back of the motor where the operator can reach it. A six-foot lead with an integrated fuse and holder runs toward the cab power source, and plastic wrap protects the wire. The motor housing is made for wet cab-door use. Confirm a suitable 12-volt circuit, fuse placement, grounding, and wire route before connection. Leave enough slack for door movement, then secure the wire away from hinges, latches, sharp edges, and operator controls. Fit check before ordering SSC normally uses this kit with its polycarbonate enclosure doors. One documented Mustang 940 question was directed back to the dealer because the factory glass system used a different motor and bolt pattern. If the machine still has an OEM glass door or an unknown aftermarket panel, send the door thickness, existing hole pattern, and photos through our contact page. Browse other skid steer cab accessories when the enclosure also needs lighting, heat, or rear visibility. Frequently asked questions Will this replace any factory wiper motor? No. It is an aftermarket kit for compatible polycarbonate doors, not a universal OEM replacement. How long is the blade? The supplied blade is 13-3/4 inches long, with an arm adjustable from 11 to 15 inches. Where is the switch? The on/off toggle is located on the operator-facing back of the motor.

Location

Frostburg, MD