BOBCAT CAB ENCLOSURE | PRO-SERIES | C/F-SERIES MODELS

Listed by SkidSteerCabs.com, LLC

This item is available in multiple configurations (for example, different machine sub-models), which can carry different prices. The price shown reflects the lowest available option -- confirm the exact price and fit for your machine with the seller before ordering. Bobcat C/F-Series Pro-Series Cab Enclosure Close in an open older Bobcat with a formed 1/2-inch Lexan polycarbonate front door, locking hardware, seals, and the parts needed for a full retrofit. The Pro-Series kit adds a hard barrier against cold wind, precipitation, brush, and loose jobsite material without depending on a complete factory door system. Order Door Only for the front door and mounting package, or select Door + Side Windows to add fitted stationary panels. You must also choose the loader's bucket-cylinder layout: one cylinder centered behind the bucket or two cylinders, one on each side. C-Series and F-Series fitment C-Series: 542B, 543, 543B, and 743. F-Series: 553, 743, 751, 753, 763, 773, 853, 863, and 873. SSC's fitment record identifies these as the 1991–1999 F-Series machines. The 743 appears in both groups, and older machines may have cab or lighting differences that are not obvious from a model number. Check the plate, count the bucket cylinders, and compare the cab opening with the product photos. Has the ROPS been modified? Is old door hardware still installed? Send photos through our contact page when anything is unclear. What comes with the selected configuration - Formed 1/2-inch Lexan polycarbonate front door. - Locking exterior handle and keys, interior pull, hinges, latch, striker, thresholds, perimeter seals, fasteners, and related mounting hardware. - Stationary polycarbonate side panels, seals, and mounting hardware with Door + Side Windows. The side panels do not slide. A roof panel and rear window are not included. C/F rear-window openings have serial-number breaks, so measure the opening rather than assuming one rear panel fits every loader. Check SSC's polycarbonate skid steer windows for model-specific and custom-order paths. Installation notes Most C/F-Series installations can use the original factory hinge location for door placement. A tap tool is supplied for holes that still need to be prepared, and the new striker mounts to the ROPS for latch alignment. Plan to remove conflicting hardware, square the door, set the hinges, and adjust the striker before tightening the seals and thresholds. Many installations take roughly one to two hours once the cab is prepared, though corrosion, old holes, and prior modifications can add time. Review the Pro-Series installation guide before starting. Frequently asked questions Why do I have to choose a bucket-cylinder layout? The one-center-cylinder and two-side-cylinder loaders use different cab geometry. Choose what is physically on the machine. Will the side windows open? No. The optional panels are stationary and bolt into place. Is this an OEM replacement door? No. It is an aftermarket retrofit kit for an open cab. Contact SSC before ordering when factory framing, sensors, wiring, or door hardware remains.

Primary fitment

bobcat Model not verified

Location

Frostburg, MD